When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

DETAILS Frame: 2017 Specialized Stumpjumper FSR Expert FACT Carbon front triangle w/ alloy rear triangle Fork: RockShox Pike RC, Travel: 150 mm Rear Shock: RockShox Monarch Plus RC3, Travel: 135 mm Handlebar: Specialized 7050 SL Alloy Riser, 740 mm Stem: PRO Koryak Alloy, 45 mm Length 31.8 Seatpost: PRO Koryak Dropper, Travel: 150 mm, Diameter: 30.9 mm Drivetrain Configuration: 1 x 11 Speed Shifters: SRAM GX Brakes: Shimano XT M8120 Front Derailleur: N/A Rear Derailleur: SRAM X1 Cranks: Race Face Aeffect Alloy, 175 mm Crank Arm Length, 32t Cassette: SRAM XG-1150, 10-42 Wheels: Race Face ARC 27 Alloy Tubeless, 29″ Weight: 27 lbs. 8 oz. GEOMETRY (measured by hand, approximate) Size: Medium Head Tube Length: 95 mm Top Tube Length (horizontal/effective): 590 mm Head Tube Angle: 67° Seat Tube Angle: 74° CONDITION We have visually inspected this bicycle with the goal of identifying and describing all issues of significant concern with regard to the need for repair or replacement. This inspection is focused mainly on the structural integrity of the frame, with less effort devoted to inspection of the components (suspension, cockpit, drivetrain, wheels). Please note that while we strive to identify all issues that might be of interest and concern to potential buyers, we might miss something that is either difficult to see or requires disassembly of the frame or components to successfully detect. —– —– —– —– Damage that exceeds the following common conditions is noted below: light scratches and small dings, including small paint chips; minor damage to finish due to cable, heel, and chain rub; and what might be typical for a bike of this type and/or age (e.g. crank arm damage from curb or rock strikes, etc.). FrameFrame has moderate wear and tear throughout, most notably (see photos): – Several paint chips on top tube- Non-drive side down tube has paint chips/scratches and scrapes- Frame protection tape on all stays is peeling Other than areas of damage noted above, frame is in fair condition. SuspensionFork has damage to stanchions and lowers and is ready to be replaced. Rear shock is in good condition. Cockpit (bar/stem/saddle/seatpost)Handlebar has moderate scratching, otherwise cockpit is in good condition. Dropper post works well. Drivetrain (shifters/brakes/derailleurs/cranks/cassette)Chain NOT included. Bottom Bracket needs to be replaced. Crankset has heavy wear. Rear brake needs to be bled. WheelsWheels have light/moderate scratches, but otherwise are in fair condition. We have not attempted to seat the tires to the rims, and therefore have not determined if the rims and tires are a good match for maintaining a reliable tubeless set-up. —– —– —– —– With regard to the current state of tune and continued serviceability of the components (cockpit, drivetrain, wheels), potential buyers should assume the following: – We have not checked the torque values of bolts and other fasteners on this bicycle, and it’s certainly possible that some, or even all, of these fasteners are not tightened to the manufacturers’ recommended torque specifications, and, in fact, might actually be loose (e.g. loose enough to cause a component or small part to move unexpectedly or fall off, or otherwise cause a safety hazard and risk of personal injury or death). – We have not checked the condition or adjustment of bearings (headset, derailleur pulley, bottom bracket, hub, freehub, suspension pivot), and some or all might need to be adjusted or replaced. – We have not checked the operation of drivetrain control components (shifters, brakes, derailleurs, suspension/dropper remote levers), and some or all might need to be adjusted. In the case of bikes with hydraulic brakes, the front and/or rear brake systems might need to be bled. – We have not evaluated the condition and remaining service life of drivetrain wear components (chainrings, cassette, chain, brake pads, disc brake rotors, cables/housing), and some or all might need to be replaced. – We have not checked the alignment of the disc brake rotors, and one or both might need to be trued. – We have not checked the alignment of the wheels, and one or both might need to be trued and/or dished. – We have not evaluated the condition of the tires or tubes, and some or all might need to be replaced. In the case of bikes with tubeless compatible rims, we have not checked to see if tubeless tape and/or tubeless valve stems are installed. —– —– —– —– This bicycle will be professionally disassembled and packed prior to shipping. Air might be let out of the suspension components in order to get the bicycle to fit into the shipping box. FedEx will require an in-person signature at the time of delivery, so please be sure to use a shipping address that someone will be at during FedEx’s normal delivery hours.

Share on Facebook

Tweet

Follow us